To configure the module, use the three buttons (typically labeled ) to define the voltage limits: P1 (Undervoltage Limit): This is the voltage at which the module will
The module will provide power until the battery hits P1, then it will disconnect the load to protect the cells. 4. Calibration and Safety Xh-m608 Manual
(Note: Specifications may vary slightly depending on the specific manufacturing batch. Always check the silk screen printing on your specific board for voltage ratings.) To configure the module, use the three buttons
Always double-check your polarity. The module does not usually have reverse-polarity protection, and a single misplaced wire can fry the main chip instantly. To configure the module
Sets the trigger for stopping a charge or starting a discharge.
