Compatible with MKS TS24/TS35 touch screens for operation without a PC. Common Wiring Setup

Ensure your software (LightBurn/LaserGRBL) is set to 115200 .

A: Yes, via USB cable. The manual specifies the USB serial port is on /dev/ttyACM0 after installing the CP210x driver (note: the board uses a CH340G, not CP2102 – the manual clarifies this in the BOM).

: Detailed circuit diagrams are available at GitHub.

https://github.com/makerbase-mks/MKS-DLC-V2.1

The official manual and technical documentation for the Makerbase MKS DLC v2.1