The Bosch ME7.1.1 is a highly sophisticated Engine Control Unit (ECU) primarily found in VAG group vehicles (Volkswagen, Audi, Porsche) and some high-end luxury models like Bentley. Understanding the pinout is essential for bench flashing, diagnostic troubleshooting, and custom tuning. Overview of Bosch ME7.1.1 Pinout
Entering is critical for full EEPROM or Flash reading when the standard OBD port is blocked. For ME7.1.1, this typically involves grounding a specific "boot pin" on the internal circuit board. bosch me711 pinout
| Pin | Function | Voltage Range | Notes | |------|-----------------------------|----------------------|---------------------------------------------| | | 5V Sensor Supply | 5.00V ±0.1V | Powers TPS, MAP, Cam sensor | | 77 | Sensor Ground Return | 0V | Reference for all 5V sensors | | 90 | Engine Speed (RPM) Sensor | AC sine wave | 58-tooth crank wheel (G4/G28) | | 91 | RPM Sensor Ground | Shield return | Do not ground externally | | 86 | Camshaft Position Sensor | 5V Hall signal | For sequential injection (G40) | | 89 | Intake Air Temp (IAT) | 0-5V thermistor | Integrated in MAF or manifold | | 101 | Manifold Absolute Pressure | 0-5V linear | 1.8T uses 2.5 bar MAP (G71) | | 97 | Throttle Position Sensor (TPS) Signal | 0.3V-4.7V | Drive-by-wire pedal? No—this is main throttle plate | | 98 | TPS Ground (Track 1) | 0V | TPS internal ground | | 99 | TPS Supply (Track 1) | 5V | From pin 60 | The Bosch ME7
Here's a summary of the Bosch ME711 pinout: For ME7